![]() ![]() Strip some of the wire insulation off the black wire, leaving it bare so you can test and solder to it later. Locate the Pass Lock 2 Wires, they will be coming out of the ignition OR on the BCM they will be located in the grey connector, Pin A6 is your yellow wire, and pin B6 will be a black wirethey should be right beside each other. Remove the appropriate dash panels to get to the wire harness. Depending on the vehicle we will be looking for 3 wires bundled together their colours are either Group. For Cavalier and Sunfire Owners you ONLY have to remove the clam shell around the ignition thats held in with 3 bolts. If you ignition is located in the steering column then you will be removing the driver side kick panels of the dash AND the clam shell around the ignition held in with torx screws. The BCM Body Control Module is there and so are the wires we need to get too. If your ignition is located in the dash then you will be removing the panels on the passenger underside toe board of the dash. ![]() ![]() Procedure This tutorial varies depending if the ignition is located On the dash close to the radio. Screw Driver optionalAlligator Clips optionalScrew driver or other tools for removing interior panels. Disable Pass Lock system to prevent from being stranded in the future. Avoid Costly repairs for an already broken Pass Lock System. This will allow you to install a remote starter and not have to purchase a bypass. Lock security in quite a few GM Vehicles. 360 Modene 2002 Automobile pdf manual download. View and Download Ferrari 360 Modene 2002 owners manual online. Hundreds of thousands of cars along the Texas Gulf Coast could be totaled after Hurricane Harvey dumped trillions of gallons of rain on the region. The following instructions will allow you to disable the Pass. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |